P72F-2AA-NNN_P72F-3AA-NNN_P74F-4AA-NNN排放阀OMEGA 

直列式或模块式安装

控制启动时下游压力的增加。气缸和其他气动装置被放松到正常操作位置，减少设备损坏和对用户造成危害的可能性。

当移除先导信号或关闭可选的手动锁定滑块时，阻断进气并排出下游空气。

可选的手动滑动可在关闭位置挂锁

电磁先导或空气先导操作

主要设计用于设备的启动和关闭

P72F系列平滑启动/排气阀设计用于单个直列式装置或作为诺冠Excelon?模块化压缩空气准备供应系统的一部分。作为一个模块化部件，这种平稳的启动/排气阀可以快速连接到过滤器、加油器、安全锁定阀和管道适配器上。使用我们的QuickClamp?和QuickClamp?以及壁装支架附件，可以在几分钟内组装和安装完整的压缩空气供应系统。

P72F-2AA-NNN_P72F-3AA-NNN_P74F-4AA-NNN排放阀OMEGA 

平滑启动/排气阀通常被称为气动排放阀。平稳启动阀通过快速控制气压来控制气动供气的启停，消除突然气压对气动设备的冲击作用。当先导供气信号消除时，排气阀阻断进气，排出下游空气。

作为一个模块化的气动元件，该调节器可以快速连接到过滤器、加油器、平稳的启动/排气阀、安全锁定阀和管道适配器上。使用我们的QuickClamp?和QuickClamp?以及壁装支架附件，可以在几分钟内组装和安装完整的压缩空气供应系统。

规格

流体：压缩空气

电磁阀操作的最大压力：取决于电磁阀额定值[不得超过17巴（250磅/平方英寸）]

先导操作的最大压力：17巴（250磅/平方英寸）

最小工作压力：3巴（44磅/平方英寸）

电磁阀工作温度：取决于电磁阀额定值[必须在-20至65°C（0至150°F）范围内]（72）[必须在-20至80°C（0至175°F）范围内]（74）

P72F-2AA-NNN_P72F-3AA-NNN_P74F-4AA-NNN排放阀OMEGA 

In-Line or Modular Installation

Controls Increase of Downstream Pressure on Start Up. Cylinders and Other Air Operated Devices are Eased Into Normal Operating Positions, Reducing the Possibility of Equipment Damage and Hazards to the User

Blocks Inlet Air and Exhausts Downstream Air When Pilot Signal is Removed or When the Optional Manual Lockout Slide is Closed

Optional Manual Slide Can be Padlocked in Closed Position

Solenoid Pilot or Air Pilot Operation

Designed Primarily for Use in Start-Up and Shutdown of Equipment

The P72F Series Smooth Start/Exhaust Valves are designed for use as a single in-line unit or as part of Norgren's Excelon? modular compressed air preparation supply system. As a modular component, this smooth start /exhaust valve can quickly be attached to filters, oilers, safety lockout valves and pipe adapters. With our Quickclamp? and Quickclamp? and wall bracket accessories, a complete compressed air supply system can be assembled and mounted in minutes. 

Smooth start/exhaust valves are commonly refered to as pneumatic dump valves. Smooth start valve controls the start up and shut down of pneumatic air supply by quickly controlling the air pressure to eliminate the hammering effect of sudden air pressure to pneumatic equipment. The exhaust valve blocks the inlet air supply and exhausts the downstream air when the pilot supply signal is removed.

As a modular pneumatic component, this regulator can quickly be attached to filters, oilers, smooth start / exhaust valves, safety lockout valves and pipe adapters. With our Quickclamp? and Quickclamp? and wall bracket accessories, a complete compressed air supply system can be assembled and mounted in minutes. 

SPECIFICATIONS 

Fluid: Compressed air 

Maximum Pressure Solenoid Operated: Depending on solenoid rating [must not exceed 17 bar(250 psig)] 

Maximum Pressure Pilot Operated: 17 bar (250 psig) 

Minimum Operating Pressure: 3 bar (44 psig) 

Operating Temperature Solenoid Operated: Dependent on solenoid rating [must be within range -20 to 65°C (0 to 150°F)](72)[must be within range -20 to 80°C(0 to 175°F)](74)